Kids assassin creed costumes
Each of these has a "rivet" made of a googly eye! To keep the googly eye from rattling I injected some clear school glue (white would work as well) with a syringe and needle. A lot of the belt pieces on the sides have little triangle shaped pieces of 2mm foam on the ends. Most of these pieces were done free-hand so I don't have pattern pieces for them.
There is a 2mm piece on top of the 6mm piece (the part painted gold). I added a 6mm piece of foam in the open part of the base piece of the gauntlet (the U-shaped part). I punched some holes with my leather punch and added the 1/2" buckles to them. I used 1/2" fake leather belts for the straps also glued on with Barge. The piece was then heat moulded by heating it up with a heat gun and shaping it by hand. The pointy side of the top is the thumb side (this gauntlet is for the left hand). I started with 6mm foam sheets and cut the main shape of gauntlet (the picture of my pattern piece is that vaguely upside-down U-shaped paper). Sanding sticks are made out of paint stirrers with sandpaper glued to them (tip from Evil Ted from YouTube). To shape the foam I use a heat gun, a dremel and sanding sticks. I use an adjustable utility knife and sharpen often and replace the blade about once per project. Make sure your knife is sharp when working with foam. All the parts of the gauntlet were glued with Barge Cement (ventilation very important).
The gauntlet was constructed out of EVA foam: 6mm and 2mm craft foam.